Prefabricated one-way sloping material made of polypropylene honeycomb that is pre-cut at a 2 percent pitch. Leading edge at the drain 1/8”; trailing edge away from drain ¾”. Comes in 30" x 30" x (1/8" - 3/4") sheets with compression strength of 230 psi. Cuts with utility knife.
Flat sheet of polypropylene honeycomb with a compression strength of 230 psi. Serves as an extension for slopes or shower pans with a run larger than 30 inches. Quick Slope can be placed on top of the Flat Panel to extend the slope.
Measurements: 30"x 30" x 5/8"
Please note: brackets are sold individually; two per drain are needed.
Metal saddle with two leveling screws, one set screw and L-shaped wall connector, one bracket is placed on either end of drain to keep drain parallel and set the correct distance from drain to wall. To be used for installation that is above the sub-floor. Distance between drain and wall may be set from 3” to 7”.
Please note: brackets are sold individually; two per drain are needed.
Metal saddle for drain body, set directly into recess in sub-floor, used to keep drain parallel and set the correct distance from drain to wall. To be used for installation that is level with the sub-floor.
Please note: brackets are sold individually; two per drain are needed.
