The thickness of the strainer itself is included in the spacer measurement.
SP1/2 is usually used with finish material thickness up to 3/8".
SP5/8 is used to set the distance between the flange and the top of the drain strainer at 5/8". This is the same distance as the distance from the waterproofing to the top of finished tile (stone).
The thickness of the strainer itself is included in the spacer measurement.
SP5/8 is usually used with finish material thickness up to 1/2".
SP3/4 is used to set the distance between the flange and the top of the drain strainer at 3/4". This is the same distance as the distance from the waterproofing to the top of finished tile (stone).
The thickness of the strainer itself is included in the spacer measurement.
SP3/4 is usually used with finish material thickness up to 5/8".
SP1 is used to set the distance between the flange and the top of the drain strainer at 1". This is the same distance as the distance from the waterproofing to the top of finished tile (stone).
The thickness of the strainer itself is included in the spacer measurement.
SP1 is usually used with finish material thickness up to 7/8".
SP1 1/2 is used to set the distance between the flange and the top of the drain strainer at 1 1/2". This is the same distance as the distance from the waterproofing to the top of finished tile (stone).
The thickness of the strainer itself is included in the spacer measurement.
SP1 1/2 is usually used with finish material thickness up to 1 3/8".
SP1 3/4 is used to set the distance between the flange and the top of the drain strainer at 1 3/4". This is the same distance as the distance from the waterproofing to the top of finished tile (stone).
The thickness of the strainer itself is included in the spacer measurement.
SP1 3/4 is usually used with finish material thickness up to 1 1/2".
SP2 1/2 is used to set the distance between the flange and the top of the drain strainer at 2 1/2". This is the same distance as the distance from the waterproofing to the top of finished tile (stone).
The thickness of the strainer itself is included in the spacer measurement.
SP2 1/2 is usually used with finish material thickness up to 2 1/4".
